|
|
(29 intermediate revisions by 2 users not shown) |
Line 1: |
Line 1: |
− | use 2-slot backplane and set slot-id dip switch to 1011 (0xB) otherwise rc1 replies do not come back, because the card is not identified properly.
| + | * [[ Testing Readout Cards ]] |
− | firmware located www.phas.ubc.ca/~mce/mcedocs/firmware
| + | * [[ Testing Bias Cards ]] |
− | CC firmware 5.0.7
| + | * [[ Testing Address Cards ]] |
− | RC firmware rc_stratix3_5.0.6_jan11_2010
| + | * [[ Testing Clock Cards]] |
− | program both cards
| + | * [[ Testing Bus Backplane]] |
− | | + | * [[ Testing VPA ]] |
− | # To make sure both cards communicate:
| + | == Test Accessories == |
− | mce_cmd -x rb cc fw_rev
| + | * [[ 2-slot Backplane ]] |
− | | |
− | and you will see:
| |
− | Line 0 : ok : 0x5000007
| |
− | | |
− | and then type:
| |
− | mce_cmd -x rb rc1 fw_rev
| |
− | and you will see
| |
− | Line 0 : ok : 0xffff0006
| |
− | run card_all_test
| |
− | run rc_test
| |
− | | |
− | log results
| |