Difference between revisions of "MCE usage"
From MCEWiki
| Line 7: | Line 7: | ||
* [[Using Python to Automate MAS |Python commanding library ]] | * [[Using Python to Automate MAS |Python commanding library ]] | ||
== Related Publication == | == Related Publication == | ||
| − | + | * [[Publications]] | |
== Application Notes == | == Application Notes == | ||
* [[MCE Timing Diagram]] | * [[MCE Timing Diagram]] | ||
Revision as of 16:47, 2 June 2016
MCE commanding
- mce_cmd - application for commanding the MCE.
- MCE Commands - especially those commands supported directly by hardware/firmware
- Virtual cards
- Python commanding library
Related Publication
Application Notes
- MCE Timing Diagram
- SQUID array setup
- Array setup programs - software
- Characterization and Locking SQUIDs with Multi-Channel Electronics [PDF] (Jun. 07, 2005)
- "Functional Description of Read-out Electronics for Time-Domain Multiplexed Bolometers for Millimeter and Sub-millimeter Astronomy" [PDF] (vol. 151, no. 3-4, J. Low-Temp Phys, May 2008)
- "Automated SQUID tuning procedure for kilo-pixel arrays of TES bolometers on the Atacama Cosmology Telescope" [PDF] (SPIE Astronomical Instrumentation Conf, Jun. 2008)
- Tuning Algorithm for ACT SQUIDs - poster [PDF]
- MCE-Cryostat Diagram - cartoons of squid chain setup, servo loop calculations, and word-sizes [PDF]
- Data acquisition
- Data Modes
- Filtered Data & the Digital 4-pole Butterworth Low-pass Filter
- Raw 50 MHz Data
- Rectangle Mode Data - recommended mode for high-rate acquisition
- Fast Data Acquisition - high-rate acquisition without rectangle mode (deprecated)
- Open loop data acquisition - for noise measurements of the SQUID chain.
- The STOP Command
- Dirfile support - set up MAS to write dirfiles directly
- Data accumulation rate - how much data does the MCE produce?
- Data files
- Python data and runfile modules - mce_data.py)
- IDL data and runfile scripts
- MCE flat-file format
- Runfile format v2
- Internal commanding
- Internal Commands - notes on internal command implementation.
- Ramp Generator
- Arbitrary Waveform Generator -- for maximum length sequences and complex impedance measurements (CC v5.0.3+)
- Fast switching of the SQ2 feedback
- mux11d support
- Configuration for mux11d operation
- MCE Signal assignment for mux11d operation
- Hybrid row select for mux11d (to combine AC and BC for multiplexing > 41 rows)
- MCE servo control
- Flux Jumping
- FSFB Clamping Commands -- to prevent unlocked detectors from ramping
- Flux-loop reset per detector
