Difference between revisions of "MDM Breakout Board"
From MCEWiki
| Line 1: | Line 1: | ||
{{Related|Accessories}} | {{Related|Accessories}} | ||
| − | This board breaks out a 100-pin MDM connector on | + | This board breaks out a 100-pin MDM connector on two 2x25-pin headers and provides 50-ohm termination on all signal pairs. It plugs in to one of the MDM connectors in the back of the MCE and can be used to probe siganls. |
* [http://www.phas.ubc.ca/%7Emce/mcedocs/hardware/schematics/MDM%20Pinout/SubrackIB-TestPinouts1b_Rev2.1.xls MDM breakout Pinout] | * [http://www.phas.ubc.ca/%7Emce/mcedocs/hardware/schematics/MDM%20Pinout/SubrackIB-TestPinouts1b_Rev2.1.xls MDM breakout Pinout] | ||
* [[Image:MDM_Breakout_Test_brd.png|400px]] | * [[Image:MDM_Breakout_Test_brd.png|400px]] | ||
[[Category:Accessories]] | [[Category:Accessories]] | ||
Revision as of 23:38, 4 May 2018
Related topics:
► Hardware
This board breaks out a 100-pin MDM connector on two 2x25-pin headers and provides 50-ohm termination on all signal pairs. It plugs in to one of the MDM connectors in the back of the MCE and can be used to probe siganls.
