Difference between revisions of "MCE firmware"
From MCEWiki
(→MCE Firmware Releases) |
(→MCE Features and How-To Guides) |
||
| Line 48: | Line 48: | ||
*** [[ Arbitrary Waveform Generator ]] (i.e. Maximum Length Sequences for Complex Impedance Measurements, 5.x.x+) | *** [[ Arbitrary Waveform Generator ]] (i.e. Maximum Length Sequences for Complex Impedance Measurements, 5.x.x+) | ||
*** [[ Ramp Generator ]] | *** [[ Ramp Generator ]] | ||
| − | *** [[ Temperature | + | *** [[ Temperature monitoring ]] |
= MCE Firmware Bugs/ Features Under Development = | = MCE Firmware Bugs/ Features Under Development = | ||
Revision as of 14:36, 17 February 2010
Contents
Critical Notes
- Always cleanly reset the MCE after a power-up or a reconfiguration! If not, MCE communication with the PC or Sync Box may not work.
> mce_reset_clean
- After an mce_reset, not all of the DAC outputs are set to zero. In addition, values written to RAM-based registers are not reset. A full reconfiguration is required for a proper reset.
> rs psc cycle_pow 1 > mce_reset_clean
MCE Firmware Releases
- Compatible Versions (CC,RC,BC,AC) . (Lists of versions of firmware to use together.)
- MCE Programming File Conversions. (Converting between sof, pof, jic, and jam files.)
- MCE Firmware Downloads
Revision information on firmware for each card:
- Clock Card (CC)
- Readout Card (RC) Rev. A/B (Stratix I)
- Readout Card (RC) Rev. C/D (Stratix III)
- Bias Card (BC)
- Address Card (AC)
- Power-Supply Unit Controller (PSUC) Rev. 1
- Power-Supply Unit Controller (PSUC) Rev. 2
MCE Features and How-To Guides
- Data Acquisition
- Fast Data Acquisition (i.e. at the Frame Rate)
- The STOP Command
- How to Configure Which Readout Cards Report Data (5.x.x+)
- How to Read a Column at the Frame Rate (5.x.x+)
- Rectangle Mode Data (5.x.x+)
- Readout Card
- Data Modes
- Filtered Data & the Digital 4-pole Butterworth Low-pass Filter
- Raw 50 MHz Data
- Flux Jumping
- FSFB Clamping Commands (i.e. To Prevent Unlocked Pixels from Ramping, 5.x.x+)
- Clock Card
- Remote Firmware Update
- Internal Commands
- Arbitrary Waveform Generator (i.e. Maximum Length Sequences for Complex Impedance Measurements, 5.x.x+)
- Ramp Generator
- Temperature monitoring
MCE Firmware Bugs/ Features Under Development
- This section has been moved to the Internal MCE Wiki Bug List.
Hardware Peripherals
Software Tools
All that you need to know about logging into our CVS repository can be found here:
We decided (sadly) NOT to migrate from CVS to SVN, if we ever do here is some information:
- SVN Manual
- Accessing the SVN Repository
- SVN Commit Guidelines
- SVN Basic Operations
