Tips on running the IB Tester
From MCEWiki
Revision as of 16:16, 30 August 2016 by Dvw (talk | contribs) (Dvw moved page Tips on running mce ib-tester to Tips on running the IB Tester)
- When you run the program, make sure the GPIB address is correctly set to 2 on multimeter.
- Make sure the right driver is installed for the GPIB controller that you are using to connect to the PC.
- When the test is running successfully, you see the display on multimeter is flashing with numbers
- Make sure output of IB-tester card ((HI and LO on front panel) are connected to ohm-meter input of multimeter HP34401A. (If you have connected to wrong input, then you hear click click noise)