Tips on running the IB Tester

From MCEWiki

IB Tester

  1. When you run the program, make sure the GPIB address is correctly set to 2 on multimeter.
  2. Make sure the right driver is installed for the GPIB controller that you are using to connect to the PC.
  3. When the test is running successfully, you see the display on multimeter is flashing with numbers
  4. Make sure output of IB-tester card ((HI and LO on front panel) are connected to ohm-meter input of multimeter HP34401A. (If you have connected to wrong input, then you hear click click noise)
Retrieved from "https://e-mode.phas.ubc.ca/mcewiki/index.php?title=Tips_on_running_the_IB_Tester&oldid=6498"