MCE commands

From MCEWiki
Revision as of 18:52, 20 January 2010 by Bburger (talk | contribs) (All Card Commands)

All Card Commands

  • These commands can be issued to any card in the MCE (cc, rc1 to rc4, bc1, bc2, bc3, ac), except the Power Supply Card. Dark-shaded rows indicate commands that remain to be implemented as of 16 May 2008.

System Commands

Clock Card Commands

Readout Card Commands

Bias Card Commands

Address Card Commands

Parameter ID Physical Address Type Firmware Revision Parameters Description
-- 0x00 -- -- -- Reserved
row_order 0x01 wb/rb all row1,

row2, ...

This command is relevant when enbl_mux = 1 or 2. Read/write the row-addressing order. A sequence of up to 41 rows is specified at once. The row numbers that are specified with this command refer to the physical channel numbers on the Address Card. Note: After this command is issued, a “flx_lp_init” command must be issued to all the readout cards to discard previous PID-loop calculations and to clean out the rest of the data pipeline. Default = 0,0,0,…