MCE commands
From MCEWiki
Contents
[hide]All Card Commands
System Commands
Clock Card Commands
Readout Card Commands
Bias Card Commands
Address Card Commands
| Parameter ID | Physical Address | Type | Firmware Revision | Parameters | Description |
|---|---|---|---|---|---|
| -- | 0x00 | -- | -- | -- | Reserved |
| row_order | 0x01 | wb/rb | all | row1,
row2, ... |
This command is relevant when enbl_mux = 1 or 2. Read/write the row-addressing order. A sequence of up to 41 rows is specified at once. The row numbers that are specified with this command refer to the physical channel numbers on the Address Card. Note: After this command is issued, a “flx_lp_init” command must be issued to all the readout cards to discard previous PID-loop calculations and to clean out the rest of the data pipeline. Default = 0,0,0,… |
