Difference between revisions of "MCE commands"
From MCEWiki
(→Address Card (ac) Commands) |
|||
Line 1: | Line 1: | ||
+ | = All Card (cc/rc#/bc#/ac) Commands = | ||
+ | = System (sys) Commands = | ||
+ | = Clock Card (cc) Commands = | ||
+ | = Readout Card (rc#) Commands = | ||
+ | = Bias Card (bc#) Commands = | ||
= Address Card (ac) Commands = | = Address Card (ac) Commands = | ||
Revision as of 18:50, 20 January 2010
Contents
All Card (cc/rc#/bc#/ac) Commands
System (sys) Commands
Clock Card (cc) Commands
Readout Card (rc#) Commands
Bias Card (bc#) Commands
Address Card (ac) Commands
Parameter ID | Physical Address | Type | Firmware Revision | Parameters | Description |
---|---|---|---|---|---|
-- | 0x00 | -- | -- | -- | Reserved |
row_order | 0x01 | wb/rb | all | row1,
row2, ... |
This command is relevant when enbl_mux = 1 or 2. Read/write the row-addressing order. A sequence of up to 41 rows is specified at once. The row numbers that are specified with this command refer to the physical channel numbers on the Address Card. Note: After this command is issued, a “flx_lp_init” command must be issued to all the readout cards to discard previous PID-loop calculations and to clean out the rest of the data pipeline. Default = 0,0,0,… |