Difference between revisions of "MCE commands"
From MCEWiki
(→Address Card (ac) Commands) |
|||
Line 1: | Line 1: | ||
− | = All Card | + | = All Card Commands = |
− | = System | + | = System Commands = |
− | = Clock Card | + | = Clock Card Commands = |
− | = Readout Card | + | = Readout Card Commands = |
− | = Bias Card | + | = Bias Card Commands = |
− | = Address Card | + | = Address Card Commands = |
{| border="1" | {| border="1" |
Revision as of 18:51, 20 January 2010
Contents
All Card Commands
System Commands
Clock Card Commands
Readout Card Commands
Bias Card Commands
Address Card Commands
Parameter ID | Physical Address | Type | Firmware Revision | Parameters | Description |
---|---|---|---|---|---|
-- | 0x00 | -- | -- | -- | Reserved |
row_order | 0x01 | wb/rb | all | row1,
row2, ... |
This command is relevant when enbl_mux = 1 or 2. Read/write the row-addressing order. A sequence of up to 41 rows is specified at once. The row numbers that are specified with this command refer to the physical channel numbers on the Address Card. Note: After this command is issued, a “flx_lp_init” command must be issued to all the readout cards to discard previous PID-loop calculations and to clean out the rest of the data pipeline. Default = 0,0,0,… |