Test plans

use 2-slot backplane and set slot-id dip switch to 1011 (0xB) otherwise rc1 replies do not come back, because the card is not identified properly. firmware located www.phas.ubc.ca/~mce/mcedocs/firmware CC firmware 5.0.7 RC firmware rc_stratix3_5.0.6_jan11_2010 program both cards

1. To make sure both cards communicate:

 mce_cmd -x rb cc fw_rev

and you will see:

 Line   0 : ok : 0x5000007

and then type:

 mce_cmd -x rb rc1 fw_rev

and you will see

 Line   0 : ok : 0xffff0006

run card_all_test run rc_test

log results