Dsp cmd
From MCEWiki
Template:Hierarchy header dsp_cmd can be used to interact with the PCI fibre card DSP program directly. It makes screwing up the fibre card program and/or your PCI bus simple. Use with caution.
Usage
dsp_cmd [-i] [-q] [-p] [-n CARD] [-f FILE | -x COMMAND] dsp_cmd [-h | -?] where: -h / -? show this help screen -i interactive mode -q quiet mode (report errors only) -p don't prefix output lines -f FILE read commands from FILE -n CARD communicate with PCI fibre card number CARD. Ignored unless Multicard MAS has been enabled. -x COMMAND execute command COMMAND
Commands
COMMAND is one of (case insenstive):
- VERS: Report the version number of the DSP code. Syntax is:
VERS
- READ: Read data from the DSP memory banks. Syntax is:
READ bank addr
- where
- bank is the memory bank to read, one of X, Y, P
- addr is the memory address
- WRITE: Write data to the DSP memory banks. Syntax is:
WRITE bank addr value
- where
- bank is the memory bank to write, one of X, Y, P
- addr is the memory address
- value is the datum to write
RESET
RESET_MCE
- QT_SET: Set a QT (quiet transfer) mode parameter. Syntax is:
QT_SET param value
- where
- param is the parameter to set, one of BASE, DELTA, NUMBER, INFORM, SIZE, TAIL, HEAD, DROPS, FLUSH, ENABLE, BURST
- value is the parameter value to write
See also
- dsp_status for a general status report from the fibre card
- PCI card hacking for examples of dsp_cmd use.