Template:MCE hardware table

From MCEWiki
Revision as of 15:14, 17 May 2017 by Dvw (talk | contribs)
Component Type Doc. Id Technical
Description
Block
Diagram
Schematics Rev. Features
Clock Card S581 [PDF] [PDF] [PDF] B5
Readout Card S582 [PDF] [PDF] [PDF] B9
[PDF] E0 Low-power RC
Bias Card S583 [PDF] [PDF] [PDF] D6 Original design
[PDF] D7/8 High-current det_bias
[PDF] D11 High-current det_bias/no heater
[PDF] E0 Multiple det_bias lines
[PDF] F0 Multi det_bias & MHz-response bias lines; Low-noise bias lines turned off
[PDF] F1 Power turned off on ln_bias
[PDF] F2 Minor change in ln_bias circuit
[PDF] F3 low 1/f-noise opamp for channel 0-15
[PDF] F4 low 1/f-noise opamp for channel 15-31
Address Card S584 [PDF] [PDF] [PDF] C4
[PDF] D0
Instrument Backplane MCEv1 5MDM S587-101 [PDF] [PDF] C3
[PDF] C5
MCEv2 5MDM C587-201 [PDF] A
MCEv2 3MDM C587-101 [PDF] [PDF] B
[PDF] C1
[PDF] C2
Bus Backplane MCEv1 S586 [PDF] [PDF] [PDF] C
MCEv2 3MDM C586-101 [PDF] A
MCEv2 5MDM C586-201 [PDF] D
Filter Board MCEv1 S587-111 [PDF] B2
MCEv2 3MDM C587-111 [PDF] A
MCEv2 5MDM C587-210 [PDF] A
MDM Breakout Board S58H-101 [XLS] B
Linear Feed Card C585-104 [PDF] B
Power Supply Unit S585-103 [DOC] [PDF] B Obsolete
Power Supply Unit Controller S585-102 [PDF] G8
Power Supply Unit Wiring S585-104 [PDF] B
: Not updated since early design stages.

External Hardware and Accessories

Description Block
Diagram
Schematics Revision
24V Power Supply and Power Distribution [PDF] [PDF] Obsolete
24V Vicor-based Power Supply [PDF] C2
Vicor Wiring Harness
[PDF] A
AC-DC Converter Unit and Power Distribution [DOC]
S588-103-101 Rectifier Board
[PDF] A
S588-104-101 Controller Board
[PDF] A
S588-105-101 Wiring
[PDF] A
Synchronizer Box [PDF] (S589) [PDF]
AC-in Rackmount: Internal Wiring (S589-102)
[PDF] [PDF] A2
AC-in Rackmount: Cable Wiring (S589-103)
[PDF]
DC-in Enclosure: Internal Wiring (C589-102)
[PDF] [PDF]
SDSU PCI Interface Board (San Diego State University) [PDF] 5A
Extender Card [PDF] (SC2-ELE-S565-008-003) [PDF]
Instrument Bus Tester [PDF] [PDF] C
2-slot Backplane [PDF] A
[PDF] B

: Note: Both Sync Box enclosures have the same PCB board inside, only the enclosure and the connectors are different. User's Guide is not yet updated for the DC-in enclosure, so all connector references are based on the rack-mount version.