Readout Card firmware
From MCEWiki
Revision as of 15:57, 15 February 2008 by 142.103.235.227 (talk)
4.0.6
- Filename : rc_v04000006_15feb2008.sof or .pof
- Feautres
- bugfix: unreliable reset due to unsafe and incomplete state machines is fixed.
- bugfix: flux_jump sign problem fixed, so far proved in const_mode, to be tested in servo_mode with cold setup.
- servo_mode=2 or ramp previously only went from 0 to ramp_amp, but now goes from -8192 to -8192+ramp_amp
- new commands are added: scratch and card_type. Scratch takes 8 values and can be used by software to detect reset.
- slot_id and fw_rev are now integrated as part of all_cards.vhd
- lvds_tx_b=0, This will allow Clock Card to use the secondary backplane lvds line and check whether RC is plugged in.
- filter_coeff in misc_banks_admin commented as it is not implemented and causes timing problems.
- Bugs
4.0.5
- 4.0.0 rc_v04000000_29aug2007.sof supports readout_row_index * bugs
- 4.0.1 rc_v04000001_06sep2007.sof
- 4.0.2 rc_v04000002_11sep2007.sof pid resolution increased to 10b, data mode 7 added
- 4.0.3 rc_v04000003_19sep2007.sof data mode 7 bit split readjusted to 10b error being bit 4 to 14
- 4.0.4 rc_v04000004_11oct2007.sof data mode 8 added (mixed filt + flux jump)
- 4.0.5 rc_v04000005_01nov2007.sof data mode 9 (mixed filt + flux jump) with windowing readjusted compared to data mode 8