Difference between revisions of "Dsp cmd"
From MCEWiki
(→Commands) |
|||
Line 32: | Line 32: | ||
* '''RESET''': Reset the DSP program. Similar to the [[dsp_reset]] command in [[mce_cmd]], except the mce_cmd command also causes the kernel driver to appropriately reconfigure quiet RP mode, which this does not. So, use that instead of this. Syntax is: | * '''RESET''': Reset the DSP program. Similar to the [[dsp_reset]] command in [[mce_cmd]], except the mce_cmd command also causes the kernel driver to appropriately reconfigure quiet RP mode, which this does not. So, use that instead of this. Syntax is: | ||
RESET | RESET | ||
+ | * '''RESET_PCI''': Perform a hard-reset of the DSP. Syntax is: | ||
+ | RESET_PCI | ||
* '''RESET_MCE''': Reset the MCE. This is entirely equivalent to the [[mce_reset]] command in [[mce_cmd]]. Syntax is: | * '''RESET_MCE''': Reset the MCE. This is entirely equivalent to the [[mce_reset]] command in [[mce_cmd]]. Syntax is: | ||
RESET_MCE | RESET_MCE |
Revision as of 18:59, 12 September 2014
Template:Hierarchy header dsp_cmd can be used to interact with the PCI fibre card DSP program directly. It makes screwing up the fibre card program and/or your PCI bus simple. Use with caution.
Usage
dsp_cmd [-i] [-q] [-p] [-n CARD] [-f FILE | -x COMMAND] dsp_cmd [-h | -?] where: -h / -? show this help screen -i interactive mode -q quiet mode (report errors only) -p don't prefix output lines -f FILE read commands from FILE -n CARD communicate with PCI fibre card number CARD. Ignored unless Multicard MAS has been enabled. -x COMMAND execute command COMMAND
Commands
COMMAND is one of (case insenstive):
- VERS: Report the version number of the DSP code. Syntax is:
VERS
- READ: Read data from the DSP memory banks. Syntax is:
READ bank addr
- where
- bank is the memory bank to read, one of X, Y, P
- addr is the memory address
- WRITE: Write data to the DSP memory banks. Syntax is:
WRITE bank addr value
- where
- bank is the memory bank to write, one of X, Y, P
- addr is the memory address
- value is the datum to write
- RESET: Reset the DSP program. Similar to the dsp_reset command in mce_cmd, except the mce_cmd command also causes the kernel driver to appropriately reconfigure quiet RP mode, which this does not. So, use that instead of this. Syntax is:
RESET
- RESET_PCI: Perform a hard-reset of the DSP. Syntax is:
RESET_PCI
- RESET_MCE: Reset the MCE. This is entirely equivalent to the mce_reset command in mce_cmd. Syntax is:
RESET_MCE
- QT_SET: Set a QT (quiet transfer) mode parameter. Syntax is:
QT_SET param arg0 arg1
- where
- param is the parameter to set, one of BASE, DELTA, NUMBER, INFORM, SIZE, TAIL, HEAD, DROPS, FLUSH, ENABLE, BURST, RP_BASE, RP_SIZE, RP_ENABLE
- arg0 and arg1 are the arguments to the parameter
See also
- dsp_status for a general status report from the fibre card
- PCI card hacking for examples of dsp_cmd use.