Difference between revisions of "MDM Breakout Board"
From MCEWiki
Line 1: | Line 1: | ||
{{Hierarchy header}} | {{Hierarchy header}} | ||
This board breaks out a 100-pin MDM connector on 2x50-pin headers and provides 50-ohm termination on all signal pairs. It plugs in to one of the MDM connectors in the back of the MCE and can be used to probe siganls. | This board breaks out a 100-pin MDM connector on 2x50-pin headers and provides 50-ohm termination on all signal pairs. It plugs in to one of the MDM connectors in the back of the MCE and can be used to probe siganls. | ||
+ | * [http://www.phas.ubc.ca/%7Emce/mcedocs/hardware/schematics/MDM%20Pinout/SubrackIB-TestPinouts1b_Rev2.1.xls MDM breakout Pinout] | ||
− | * [[Image:MDM_Breakout_Test_brd.png] | + | * [[Image:MDM_Breakout_Test_brd.png|400px]] |
− | |||
[[Category:Hardware]] | [[Category:Hardware]] |
Revision as of 13:30, 30 October 2012
Template:Hierarchy header This board breaks out a 100-pin MDM connector on 2x50-pin headers and provides 50-ohm termination on all signal pairs. It plugs in to one of the MDM connectors in the back of the MCE and can be used to probe siganls.